How To Solder Stereo Harness

It is a larger diameter tube that slips on over your soldered connection once in position hold the soldering iron to it to heat it up and the tube will shrink tightly over the connection to insulate it.

How to solder stereo harness. Also you need to cut and join wires together. Turn on your soldering iron and let it heat up completely which should only take a few minutes. Secure the harness so that the wiring is facing you.

Solder a wire to every pin identified by the pinout diagram. Although the car stereo wiring harness adapters allow for plug-and-play head unit installation the most common way is to cut the factory harness and solder in the car stereo wiring harness during installation. Use rosin core solder.

Step 1 Look up your make and model to buy the correct harness adapter. So solder with the requiored heat only. Standalone Wiring Harness For Drive-by-cable Ls1 With T56 Manual Transmission.

By using one or more of the methods illustrated below you can be sure that your connections will last for years to comeand that your. As far as solder VS crimpbutt splices. Slide the existing wire into the open side of the connector then put the end of the wire you wish to connect to it into the other side.

Group and tape the power ACCY and ground wiring together. The soldering iron should be heating the wires and the solder itself applied to the wires not iron. Wiring a Car Stereo With No Factory Harness.

I extended the accessory wire slightly by soldering and heat shrinking another 8 inches of 18-gauge Red wire to the one Pioneer included Step 3. They then solder the head unit during installation. Hold the end of your solder directly on the end of the iron so a thin layer of it melts onto the iron.