How To Solder Three Wires Together

Place the tip of the iron on the wire and let it heat for a few seconds.

How to solder three wires together. Cover With Heat Shrink. When done properly you have a strong conductive connection that turns two separate wires into one. In the case of stranded wire always keep the individual strands together after stripping the insulation by firmly twisting them together or better still applying a little solder.

Your solder will be applied opposite from the iron on top of the wire. Heat up the joint and melt the solder with the wire not the soldering iron. Next is a process called pre-tinning.

The challenge is holding the wires in place long enough for the solder to cure. Hold it on the wire for 3-4 seconds. Step 3 Plug the soldering guniron into an electrical outlet and allow it to heat up for about three to five minutes.

Remove the insulation from both ends of the wires youll be soldering together. If the wire is stranded twist the strands together with your fingers. Soldering Two Wires.

If the wire is stranded use your fingers to twist the strands together. Make sure your soldering iron is fully heated and touch the tip to the end of one of the wires. Its not too difficult.

Then add some solder until the wire is soaked with solder. Lay them together overlapping at the soldered part then blob them together. Dont use too much.