How To Use Bosch Router Table As A Jointer

Is it possible to use a router table as a jointer.

How to use bosch router table as a jointer. Straight edges on boards or plywood. To check if your board is on the right length place it on the infeed table. Examine the large hole in the middle of the router table.

The glue edge is just as good as using a jointer. Youll have a truer cut when trying to use a router as a jointer with that constant cutting edge. The important thing is to make sure that the in-feed and the out-feed side of the fence are parallel and that the out-feedside of the fence is lined up with top dead center of the cut radius of the bit.

The cabinet-style construction is ideal for stability storage and dust collection. By using a router table fence thats equipped with an offset fence youll be able to dial in the thickness of cut by adjusting the position of your infeed fence in relation to the outfeed side. The Bosch RA1181 Benchtop Router Table provides a premium large work surface for woodworking and routing.

Set the fence so the out feed half is even with the cutting edge of the bit. Im born 1959 and build my first box jointer my palm router i made before table and not top of table box joint ji. And its 2-12-inch dust collection port.

One of the main applications for using the router as a jointer is on very erratic grained woods photo 5 - above. Now isolate the bearing of the flush trim bit with the out feed side of the fence only photo 4 - below. Make sure the insert plate holding the router tool is properly attached and sits in flush with a router table surface.

Yes a very narrow jointer good for edge joining but too narrow for face jointing. Using the right technique you should be able to balance the board on the table thereby achieving a straight edge. Yes a very narrow jointer good for edge joining but too narrow for face jointing.