How To Use A Router For Wood

The correct sequence for routing all four edges of a board is to start on the end grain then cut long grain end grain and long grain.

How to use a router for wood. The blade will turn clock-wise go with that action. It is always recommended to use the router in forward motion never backward. Wood routers are the ultimate go-to tool of every craftsman.

When routing the inside edge of a frame move in a clockwise direction Photo 10. You can use this tool to decorate the edges or surfaces of a piece of wood or you can cut a chase into the side of a piece of wood to hide electrical cables or pipes. You clamp the tail board into the template and then use a dovetail router bit to cut the tails.

This can cause damage to your project or in worst cases can fly off and cause danger to you. If possible use the same wood and bit youll be using on your project. Rout the inside edge of a frame in a clockwise direction.

The router bit makes groove cut on the wood by the rotation of the bits. When using a router always make sure you feed your router from left to right this will make sure the blade of the cutter makes correct contact with the wood being machined. A wood router is a handheld or bench secured tool that uses an electric motor to turn a cutting tool attached to a spindle at high RPMs.

The cutting tool shaves away bits of material as it passes along the workpiece. The bit should be sharp and clean. Also push the router very slowly and also trace the lines with the help of bits.

Next install the pin board into the template and use a straight router bit to cut the pins. Gather Materials and Safety Equipment. Many router kits include a single motor that can be interchanged between a pair of bases for versatility.