How To Solder Two Thick Wires Together

Then add some solder until the wire is soaked with solder.

How to solder two thick wires together. Place tip of soldering iron at the middle of the connection to activate the flux. Solder the verb means to join together two pieces of metal in what is called a solder joint. Slide heatshrink glue lined sleeving over the join on the soldered bit only then slide more glue lined heatshrink over the whole of the area an seal the whole lot.

Work from multiple angles and make sure to get thorough coverage. You should not be able to pull the bundle apart once the solder has cooled. When done properly you have a strong conductive connection that turns two separate wires into one.

Hold the two tinned wires on top of each other and touch the soldering iron to both wires. Solder as a word can be used in two different ways. Obviously these should not be connected to.

2 Heat the joint with a soldering iron or pencil from underneath. Secure both sides of the rejoined wire so they wont move when touched with the iron. Strip about 6 mm 14 from the end of the wire.

Youll get a straight wire that has a little sideways bump in it so get a larger shrink tube to isolate it youll need two times the diameter of one wire. A bit thicker than 116 inch. Solder is a metal alloy with a low melting temperature point used alongside a soldering iron to permanently join together two metals with a higher melting point.

You can also use soldering to fuse two wires together. Un-twist the strands fan out slide the ends strands together overlapping each of the strands so they intermingle roll this area splice in your hands fingers now solder the strands all together on masse. You should see the solder flow between the strands through the whole bundle.