How Do You Solder Two Wires Together

Let the solder melt and flow over the wires.

How do you solder two wires together. The process of soldering is taking two or more wires and joining them together and then using heat to melt electrical solder connecting those two wires permanently. This simultaneously melts the solder and shrinks the sleeve. Twist and fold 2.

If your joints are going to be wire-to-wire or wire-to-lead you can twist them together tightly before soldering. Youll also need some PVC shrink tube. The aim is to coat the wire with a thin layer of solder.

However I typically solder the wires after performing the twist and before folding the connection back against the side of one of the pieces of wire. Pass one wire in each end so that they cross over in the solder ring then simply apply a heat gun. Connecting two wires can be done with a wire stripper and electrical tape but to make a proper connection you should solder them together or at least use wire nuts.

Just seat them where you want them and find a way to hold them in place with clips or by bending the leads outward slightly so they stay put when you turn the circuit board over. Use large wheel collars. This tool worked the best for me in the automotive application and make it a breeze get that tuff to reach wires repaired soldered and sealed properly.

A simple solution if you dont have a soldering iron handy is to use heat shrink solder sleeves. After wrapping the wires tightly around each other use a soldering iron to heat the wrapped portion of the wires. Step 7 Remove the wires from the vise when they have cooled and using the needle-nose pliers twist the two soldered wires together to form an initial bond.

The process will form a. When you solder items together youll typically be using the hot metal tip of the iron to melt a small amount of solder alloy around and between the components or surfaces being joined. These contain a ring of low temperature solder in the centre of a heat shrink tube.