How To Solder Wires Together With A Soldering Iron

To solder these wires together you will have to heat the ends of these wires and then apply your solder to the opposite side of where the wires are exposed.

How to solder wires together with a soldering iron. The simplest kind of soldering is just connecting two wires together. In this way the melted solder will get into the header. Add the proper amount of solder into the connection.

Soldering irons that are designed for use with nichrome wire tend to. Hold the two tinned wires on top of each other and touch both wires with the soldering iron. Do the same with the wire.

Avoid applying your solder directly on the heated area since there will be a build-up of soot and other chemical residues which will make it relatively challenging for the solder to stick properly. If you cannot afford the nichrome wire buy just a gas torch for less than 10 from the local hardware store. One is to touch the solder with iron and transfer this attached filler into the targeted tips directly from iron.

Place tip of soldering iron at the middle of the connection to activate the flux. Keeping the tip of the soldering iron pressed in place move the solder wire along the wires coating it as you go. Solder the Wire Joint.

Makes it easier to easily solder wires together in tight areas. This process should melt the solder and coat both wires evenly. When you are tinning the wires the resin will help the solder flow smoothly.

You simply touch the freshly tinned tip of your soldering iron onto the bare wires for a couple of seconds and then apply the solder at which point it will smoke and flow over the wires almost immediately and you can withdraw the solder and then the iron and you should be left with a bright silver joint like the one below. Remove the soldering iron and allow the soldered connection to cool and harden for a few seconds. How to Solder Wires Together Correctly Like a Pro.