How To Solder Two Small Wires Together
The wires are then twisted together after which they are folded back against the side of one of the pieces of wire as shown below.
How to solder two small wires together. By first joining wires together you can solder them in place for a strong connection. Let the solder melt and flow over the wires. When done properly you have a strong conductive connection that turns two separate wires into one.
Another approach that sometimes works is to first use a few turns of much finer wire to hold the two main wires together the whole blob then being soldered. Apply a small amount of solder flux. Use a thin solid wire 28 AWG-30 AWG and wrap it around both wires.
A solder join - wires twisted together not so good. They should be propped up off the workspace so you can have access to the area under the wires. Place soldering iron under the wire.
All of these approaches require that the wire material be solder-able with any enamel or oxide coating scrubbed off. Touch the tip of the soldering iron to the copper wires. If possible you should twist the wires in-line before soldering as this makes a stronger and neater join than twisting the ends together.
You should cover all of the wires with solder but still be able to see the strands when finished. Tin the soldering gun ie melt a little solder on it. The process of soldering is taking two or more wires and joining them together and then using heat to melt electrical solder connecting those two wires permanently.
Twisting the wires together and soldering is often the best method but there are two ways of doing this. Here is the short video to show you the basics of soldering two pieces of metal together. To be honest this is the way that.