How To Solder Radio Wiring Harness

After searching around for wiring info for the stock SVT sub and amp and unable to find any usable info.

How to solder radio wiring harness. These differentials in brittleness create areas where vibration can lead to breaks in the wire. Also high temperatures on top of the engine makes solder brittle. If it works fine tuck all the wiring.

Group and tape the speaker leads together. Secure the harness so that the wiring is facing you. Slide the existing wire into the open side of the connector then put the end of the wire you wish to connect to it into the other side.

The Becker harness plugs into the back of the head unit but I have to splice that harness to the cars harness. Tap the end of the 6337 solder on top of the wire splice so the solder melts down into the wires. Ad Our Secret is our People.

I decided to make a small how-to for you guys. So I have to twist crimp or solder those connections. Cable tieslacing shall be installed at both ends of a splice or solder sleeve but placement shall not violate stress relief requirements.

Solder the wires accordingly to these pins ensuring that the pins dont touch each other in the process. Once youve connected your radio wires secure them with solder or heat-shrink wrap. In most installations simply connect the wiring harness to the Trig unit and stow any excess wire in a safe and tidy way.

Soldering Seems to be discouraged for automotive use because stranded wire gets stiff and breaks under vibration. Ultrasonic welding Seems to be the professional choice - no access to such a machine tough. Just put the wire through a piece of the tube first then twist and solder the core.