How To Solder Automotive Wiring

I will show you how to solder wires together the right way to seal the solder joint with heat shrink is a must and you also need to make sure you do not have a cold solder joint.

How to solder automotive wiring. Outer diameter of single core wire. Hold the two tinned wires on top of each other and touch the soldering iron to both wires. Keep the soldering iron on the bottom of the wire to continue heating it.

Do not over tin the wire or solder may flow up under the wires insulation causing it become rigid or you will end up with globs of solder on the terminal that will have to be removed. Tin the tip of the iron and then clean it with a sponge before heating the wire. Aside from your solder and soldering iron youll also need.

Dead link also not available on the Wayback. Do you use electrical tape or shrink tubing. Tap the end of the 6337 solder on top of the wire splice so the solder melts down into the wires.

You might be better off introducing them to croc clips and just leave it with them that some wires are difficult to solder. SOLDERING KIT INCLUDED60-watt digital soldering station with side-mounted solder roller holder removable built-in soldering iron holder to ensure soldering iron safety cleaning Sponge to remove solder residue for future use 2 helping hands to fix welded objects and solder tips holder to put solder tips. Use the Micro Torch with the Hot Knife attachment to strip and prepare the wire ends for soldering.

If your re-wiring your car or truck then this is a MUST Video For YOU. Continue melting the solder until theres a thin layer of solder covering all of the exposed wire. When soldering any connection it.

In automotive applications where there are many 16 or 18 gauge wires it is extremely easy to overheat when soldering. A few tips and tricks to use when soldering is to first always make sure you do not have a cold solder joint make sure you are using the right solder for the job and always make sure you seal your solder joint from all types of weather. I have tried to get the solder to attach to the wire with and without flux but no luck.