How To Remove Tip From Weller Soldering Iron

Place the desired tip into the retaining sleeve and slide it back onto the soldering.

How to remove tip from weller soldering iron. It took a lot of effort with tip tinnercleaning compound to make the solder wet the tip again. Switch on the Soldering Station or the Iron and Make sure it is Hot Enough. If some of the oxides are just sticking really well you could try to mildly abrade them on a brass sponge copper braid or similar but you cant be too hard or you will damage the iron plating good tips are typically copper core plated with iron then chromium everywhere but the working area.

Good soldering process is important. Install the prepared tip in your soldering iron. Weller is a good manufacturer but be aware that there are two types of soldering tips.

This should lead to a clean shiny tip ready for use for more info see this video. Wipe OFF the solder on the Cleaning Sponge or Copper Wool. Both will die if you use ordinary solder flux as sold at Home Depot etc.

The best tip tinner is your solder--tips should always be coated with a small amount of solder. Clean the tinned tip and you have a refurbished soldering tip. Weller Soldering Iron 336B.

Try not to leave the iron sitting hot on the bench while not in use. Unplated copper or iron soldering tips will take tin at blank spots so the tip must be blank or polished. As soft as possible.

Start by plugging it in and waiting for it to heat up. Wipe the tip clean and re-tin it between every joint. Changing the soldering tips on a PES51 pencil is very simple.