How To Re Tin A Soldering Iron Tip

Plug in the iron and switch it on.

How to re tin a soldering iron tip. Then tilt the tip and align it to the pointed part to restore its shape. At this point you have made a little hole in the block and you want to feed in a little solder keep rubbing it around and the tip will be re-tinned. Soak the sponge using the water squeeze it out a little then use it to clean the tip of the soldering iron.

Of the tip regularly. Also you should try to avoid applying solder to the soldering iron tip and letting the solder flow onto the connection. Sit for a few minutes before wiping it clean.

Only apply flux to the surfaces of the connection to be soldered. After a minute or two the iron should be hot enough to steam when touched to the sponge. Then immediately re-tin the tip with rosin core solder.

Clear a work area then grab your soldering iron a solder sponge and water. Its particularly hard to keep tips tinned with modern lead-free. If you over-clean the tip after use and then leave the iron in the holder there is a slight risk of oxide on the iron plating - I always clean and tin the tip immediately before using and leave any residual solder on the tip while its in the holder.

The layer itself is very thin. Tin The Soldering Irons Tip. Never apply flux directly to a soldering iron tip.

Melt some good quality of solder wire on the Tip. Turn the solder pot on and allow it to achieve the desired temperature. Use set screws to re-assemble the iron.