How To Clean A Weller Soldering Iron Tip

Sal ammoniac for cleaning your stained glass soldering iron tip comes in a solid block form similar to that of a bar of soap.

How to clean a weller soldering iron tip. After trying both the sponge and flux to clean the tip of your soldering iron sal ammoniac would be the next step if the others didnt work. Clean the tip immediately after the solder iron to limit buildup over time. And if you try to de- solder anything you will damage the tip.

Put in the new soldering tip and put the screw back in by turning it clockwise with the screwdriver. Unplug the soldering iron and allow it to cool completely. Apart from removing the flux off it is essential to clean off surplus solder.

Leads from the 5 conductor cord two wires to sensor two to heater ground. For very fine SMD solder joints you may repeat this. Tip the soldering iron downward and the loose tip should now fall out.

Use a damp sponge to clean the tip and wipe it off quickly to avoid cooling the tip excessively. Clean the tip After every cycle and before you start to solder always clean your tip. Melt some good quality of solder wire on the Tip.

Switch on the Soldering Station or the Iron and Make sure it is Hot Enough. Turn off your solder iron and let it cool down for 15-20 minutes before cleaning the tip. In addition to it.

The flux in tip cleaner removes the oxidation and build up from the soldering iron tip and then the solder re-tins the tip ready for use. If Ill be sucessfull in outsourcing parts and services. Repeat the Process 3-4 Times until the Soldering Tips start Shining.