How Do You Solder Electrical Wires

Step 2 - Choose the Right Size Wire Connector.

How do you solder electrical wires. Use rosin core solder. Now heat both the conductor you are trying to solder and the pad you are trying to solder to. Your solder will be applied opposite from the iron on top of the wire.

Touch the tip of the soldering iron to the copper wires. Step 3 - Strip the Wires that are Being Connected. This tool worked the best for me in the automotive application and make it a breeze get that tuff to reach wires repaired soldered and sealed.

Step 6 - Twist the Connector On. The connection should not have any uneven globs of solder and the solder should penetrate both wires. At some point over the next 2-10 seconds depending on how hot your iron is the wires will be hot enough to melt the solder.

Put the leads through the board and bend them so that they stay dont fall out. If you want you can add soldering resin to the wire filaments. Step 1 - Turn Off the Power.

For small wire form a shepherds crook in each wire to link them together or twist them together pigtail splice them solder. If so then refer to the products list above and follow these steps to successfully solder an electronic component. When you are tinning the wires the resin will help the solder flow smoothly.

A pig-tail where the wires are bent at a 90-degree angle to the rest of the wire is NOT a suitable connection and will cause problems dont do. To do this heat up the soldering iron and touch the solder to the tip of the iron so that you cover the tip in a thin layer of solder. Then twist the filaments of each wire tightly to make them orderly.