Correct Way To Solder Wires

Clean the ends of the stripped wire with some sandpaper or steel wool.

Correct way to solder wires. But even in the soldering community theres still room to argue. Remove the soldering iron and wait a few seconds to let the soldered. This is the only way you should ever join 2 wires together.

Heat the wires so they are hot enough to melt the solder then. Run wires through grooves and make sure the rods stick out by 10mm at bottom of piece of wood. How To Solder Wires.

Carve a groove on each side of the 20x40 sides of the wood it should be enough so that the rods fit through the groove. Tin the tip of the iron and then clean it with a sponge before heating the wire. The heat shrink should be cut so that it is about a 12 longer than the area to be soldered.

The following steps are involved to get an answer to the question How to solder wires. Ad Quality Solder Wire Drawing Machine. There is one way to twist wires together for soldering- a horizontal twist that yields a continues length of wire.

Put electrical tape around piece of wood to keep a hold on rods. We will learn how to solder wires in this section covering the steps of soldering wires. This solder melts at about 370 F.

It offers the lowest resistance and the best vibrationfatigue protection. Once the connection evenly turns the correct silver color of solder remove the soldering iron and allow the joint to cool. Its vital to use a soldering iron that brings the wire up to temperature quickly.