Can A Router Table Be Used As A Jointer

Make sure your infeed and outfeed guides are long enough and rigid enough then you can set it up like a jointer layed on its side.

Can a router table be used as a jointer. The router is now ready to use as a jointer with the bit and guide boards fence in place. In this short video furniture maker and Fine Woodworking contributing author Gregory Paolini demonstrates his technique for jointing wood on the router table. You can save both time and money if you use your router table as a jointer.

By using a router table fence thats equipped with an offset fence youll be able to dial in the thickness of cut by adjusting the position of your infeed fence in relation to the outfeed side. The rigid router fence will keep the laminate from flexing. You CAN joint on a router table but it isnt always the best choice especially with thicker lumber.

The technique for making jointing cuts on the router table is very similar to that used on a jointer. Make sure your infeed and outfeed guides are long enough and rigid enough then you can set it up like a jointer layed on its side. Yes although there will be limitations to board depth based on bit size.

You may need to tweak it for your table. For more information on the best router for your table read our reviews. Im not trying to make it sound difficult it just requires care.

A simple table saw jig will also do an excellent job of edge jointing a board so you may not need to wait until your router table arrives. For longer stock lay out your boards on a scrap piece of ply in the order that you want them laminated and clamp them at both ends to your bench photo 10. Place the piece that you want to be jointed on the router.

1 Insert your straight cut bit into the router and a guide-bushing in the router base plate. It is a money-saving alternative to a dedicated pivotal jointer. Photo 3 Photo 4.