Best Way To Solder 3 Wires Together

There is nothing wrong with soldering wires together and then heat-shrinking them making sure that the heatshrink is long enough to take the load off the area of wire that solder will have run.

Best way to solder 3 wires together. Heres the right way to do it. For this example we solder the same two 18 AWG wires together end to end. First you need to strip the wires then add your heat shrink tubing physically connect the wiressolder the wires together and then shrink that heat shrink tubing to make a waterproof connection.

Run the solder over the entire splice so it can melt and travel into the gaps between the wires. Tap the end of the 6337 solder on top of the wire splice so the solder melts down into the wires. If you decide that soldering is a way to go I would recommend this kit for you if you have smaller jobs at hand.

Apply solder to the top until molten solder wicks into the joint. Tin each tip and then use a 3rd hand to hold one while you hold the other and melt the solder from one to the other. Strip about 34 inch of insulation from both wires.

Since there are no sensitive components nearby we can use lots of heat and a broad chisel tip in this case I set the iron to 430C. Capillary action plays an important role in distributing the solder throughout the splice. 1 Strip the wires of about 12 in.

This video starts by showing the simplest technique for twisting two wires together which commences by baring the ends and overlaying them at 90 to each other as shown below. Crimping and soldering are two different ways of creating a cable connection. You interweave the threads of the wires together before soldering the joint solid.

You will burn your workbench and produce bad solder joints. The first step is you need to strip your wires. The challenge is holding the wires in place long enough for the solder to cure.