Best Way To Clean Solder Tip

Just try to wipe it off after every 4-5 solder joints.

Best way to clean solder tip. Take a wet sponge and rub it over the top of the solder iron. After trying both the sponge and flux to clean the tip of your soldering iron sal ammoniac would be the next step if the others didnt work. Molten solder should adhere readily to a cold screwdriver.

Turn the top section counterclockwise until you can pull the pieces apart then set them down on a flat work surface. This should remove the oxides unless the oxidation has been allowed to build up excessively. A polyurethane foam bar with embedded abrasives which is used to polish the working end of the tip to remove surface oxides.

Turn it off as soon as you have finished soldering. If your soldering tip becomes detinned oxidized it can be restored in a number of ways. If the soldering iron tip isnt responding to the extra solder revive dirty tips by using a tip cleaner often referred to as tip tinner.

Once cleaned the tip surface should be covered with a thick coating of solder. To use the Tip tinnercleaner heat the soldering iron. You also can clean your soldering iron tip with a sponge while using it to keep it clean.

The wire sponges made for cleaning soldering tips are probably better but you can also just use a brass or copper coated pot scrubber from the grocery store. Now remove the tip and clean it with a moist sponge to remove the cleaner. The brass wool is very efficient and provide a perfect cleanning.

Tip Tinner copper is used to deoxidize and clean your soldering iron tip so that the solder can stick to the iron again. It doesnt matter too much if its ugly as long as you can get a nice shiny bit right at the tip. Your soldering iron is hot enough when some solder quickly melts on the tip which you should do anyway before starting.